Beta 1947G Mode D'emploi page 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• Check that the air gun is in good condition; make sure that no parts are damaged.
• Only use accessories suitable for the required job, like:
•Standard cartridges, made of either aluminium or plastic, for applying grease
• Do not modify the air gun. This can reduce the effectiveness of safety measures
and increase operator risk.
• Have the pneumatic tool repaired only through a trained repair person. Only use original r
eplacement parts.
PERSONNEL SAFETY
• Stay alert; watch what you are doing. Do not use the pneumatic tool while tired
or under the influence of drugs, alcohol, or medication.
• Always use the following personal protective equipment:
• eye protection;
• hearing protection;
• safety shoes;
• protective gloves against physical agents.
• Make sure you are in a safe position, keeping proper balance at all times. A safe working position
and a proper body posture enable better control of the pneumatic tool in unexpected situations.
• Do not directly inhale the exhaust air, and prevent it from getting into your eyes. The exhaust air
of the pneumatic tool can contain water, oil, metal particles and impurities,
which may cause hazards.
AIR GREASE GUN SAFETY
• Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
• Operators and maintenance personnel should be physically able to handle the weight and power
of the pneumatic tool.
If a specially conducted survey suggests that the daily exposure to vibration generated from
the pneumatic tool exceeds the limit under the regulations in force in the respective country,
anti-vibration devices must be used.
• Hold the pneumatic tool with a secure grip.
• Check the connections and the air supply lines. All units, couplers and hoses should conform
to the product specifications in terms of pressure and air volume. Too low pressure impairs
the function of the pneumatic tool; too high pressure can cause damage and/or injury.
• Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from
heat, oil and rotating parts. Immediately replace any damaged hose. A defective feed pipe may cause
uncontrolled movements of the compressed air pipe. Raised dust or chips may cause eye injury.
Make sure that the hose clamps are always secured firmly.
• Never carry the pneumatic tool by the hose.
8
EN I