Declaration Of Conformity - Beta 1910/8 Notice D'utilisation Et Instructions

Table des Matières

Les langues disponibles

USE

Air supply connection

For correct use of the automatic hose reel, always keep to a maximum pressure of 15 bars. Feed the hose reel with clean, condensate-

free air. Excessively high pressure or humidity in supply air may damage the tool or cause injury.

Hose reel adjustment

The automatic hose reel is fitted with a spring winding system with automatic locking at the required length. Adjust the hose winding

limiting device as needed.

Hose pulling

Pull the hose as follows:

–

pull the hose by hand until the required length is achieved;

–

the hose is locked by means of the spring ratchet, which is activated in certain pulling points of the hose, which can be heard

through the mechanical noise of the engaged ratchet;

–

the automatic safety catch locks the hose, thereby preventing it from winding completely and rapidly.

Hose winding

Wind the hose as follows:

–

pull the hose by hand to automatically release the ratchet;

–

ease the hose while winding it, being careful to avoid interference with persons or things;

–

the hose is fitted with a hose winding limiting device which stops it, thereby preventing it from winding completely.

Safety catch disconnection

The safety catch of the hose reel can be can cut out as follows:

–

open the side cover on the hose reel by unscrewing its fixing screws;

–

release the ratchet spring from fixing point 1 and hook it to fixing point 0 (for item 1910/8, picture 2);

–

release the ratchet spring from fixing point 1 and hook it to fixing point 0 (for item 1910/10, picture 3);

–

put back the cover, replacing and tightening the screws correctly. During this operation, the hose must be completely rewound.

Always disconnect the air supply before carrying out any jobs on the hose reel.

Lubrication

The hose reel should be connected to a compressed air supply system complete with filtering system for solid particles, if need be.

MAINTENANCE

Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s repair

centre.

DISPOSAL

The hose reel must be disposed of in accordance with the law provisions in force in the country where it is used.

WARRANTY

This equipment is manufactured and tested in accordance with current EU regulations. It is covered by a 12-month warranty for

professional use or a 24-month warranty for nonprofessional use.

We will repair any breakdowns caused by material or manufacturing defects, by fixing the defective pieces or replacing them at our

discretion.

Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.

This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls.

In addition, this warranty will no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer

service in pieces.

This warranty explicitly excludes any damage caused to people and/or things, whether direct or consequential.

We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine

Directive 2006/42/EC and amendments thereto, as well as with the following standard:

• EN ISO 12100

The Technical Brochure is available at:

BETA UTENSILI S.P.A.

Via A. Volta 18 - 20845 Sovico (MB) - ITALY

Name and title of person in charge

MASSIMO CICERI

(Managing Director)

BETA UTENSILI S.P.A.

Via A. Volta 18

20845 Sovico (MB)

ITALY