Declaration Of Conformity - Beta 1945P Notice D'utilisation Et Instructions

EN
OPERATION MANUAL AND INSTRUCTIONS
Periodically, depending on the frequency of use, clean the pneumatic tool. If any operation defects that cannot be dealt with
through the instructions should be shown, send the pneumatic tool to the repair centre.
LUBRICATION
The pneumatic tool must be connected to a filter-lubricator unit provided with a microfog mixer (we recommend Beta item
1919F1/4). This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 5).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre through your Beta dealer.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force
in your country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month
warranty for professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or
replacing them at our discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty
will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition,
this warranty will no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the
customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.


DECLARATION OF CONFORMITY

We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions
of Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN 792-13
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
13