Dometic Waeco CoolPower EPS100 Notice De Montage Et D'utilisation page 15

EPS-100W.book Seite 15 Donnerstag, 19. August 2010 1:21 13
CoolPower EPS100
Electronic devices are not toys!
Keep electrical appliances out of reach from children or infirm
persons. Do not let them use the appliances without super-
vision.
2.2 Safety when installing the device
Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
For installation on boats
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
Electrical cables
If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12 V DC cable in the
same duct!
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
General safety instructions
15