Interventions On The Machine; Replacing Wheels; Replacing A Fuse - Dolmar RM-72.13 H Manuel D'utilisation

6.2.4 Greasing
Every 100 hours grease:
– steering pins, using the two
grease guns (1);
2

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut, please contact your
Dealer for the adjustment of the alignment of the cutting deck.
EN 24
1
– the progress control lever joint us-
ing the grease gun (2) accessible
from the hatch placed at the bot-
tom of the seat.

6.3.2 Replacing wheels

Stop the machine on flat
ground and put a block
under a load-bearing part
of the frame on the side
that the wheel is to be
changed.
The wheels are held by a
snap ring (1) which can
be eased off with a
screwdriver.
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external diameter
does not exceed 8-10 mm; on the contrary, to prevent an uneven
cut it will be necessary to adjust the alignment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply grease
to the axle. Put the snap ring (1) and supporting washer (2) back
in place.
6.3.3 Changing and repairing tyres
All puncture repairs or replacements will have to be carried out by a
tyre repair expert in accordance with the methods for the kind of
tyre used.

6.3.4 Replacing a fuse

The machine is fitted with fuses (1) with different capacities and
functions. Specifically:
1
2
1