Interventions On The Machine - Dolmar TM-92.14 Manuel D'utilisation

Operation
2.6
Spark plug points cleaning and check
2.7
Replace spark plug
See the engine manual for the full list and frequency.
1)
At the first signs of any malfunction, contact your Dealer.
2)
The operation must be carried out by your Dealer or a specialized Service Centre.
3)
General lubrication of all joints should also be carried out whenever the machine is to be left un-
4)
used for a long period.
6.2.1 Engine (Fig. 6.1)
IMPORTANT Follow all the instructions in the
engine manual.
To empty the oil from the engine, hold the ex-
tension tube (1) firmly in place and unscrew the
drain plug (2).
When refitting the plug (2) make sure the seal
(3) is positioned correctly and tighten it as far as
possible, holding the extension tube (1) firmly in
place.
6.2.2 Rear axle
This is a sealed single unit that does not require
maintenance. It is permanently lubricated and
its lubricant does not need changing or topping
up.
6.2.3 Battery (Fig. 6.2)
To ensure long life to the battery it is essential to
keep it carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time
after purchase;
– before leaving the machine disused for a long
period;
– before starting up the machine after a pro-
longed period of inactivity.
Carefully read and observe the battery recharg-
ing instructions in the booklet provided with the
battery. Failure in following the procedure or in
charging the battery could permanently damage
the battery elements.
A flat battery must be recharged as soon as
possible.
IMPORTANT Recharging must be done us-
ing a battery charger at constant voltage. Other
recharging systems can irreversibly damage the
battery.
The machine comes with a connector (1) for re-
charging; this is connected to the corresponding
Hours Completed (Date or Hours)
...
...
connector for the special maintenance battery-
charger supplied (if included) or available on
request (see 8.5).
IMPORTANT This connector must only be
used for connection to the maintenance battery-
charger indicated by the Manufacturer. For its
use:
– follow the indications given in the relative in-
structions manual;
– follow the instructions in the battery manual.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Aligning the cutting-means
assembly (Fig. 6.3)
The cutting-means assembly should be prop-
erly adjusted to obtain an evenly mown lawn.
If mowing is uneven, check the tyre pressure.
If this is not sufficient to achieve an even cut,
please contact your Dealer to adjust the align-
ment of the cutting-means assembly.
6.3.2 Replacing the wheels (Fig. 6.4)
Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels are held by a snap ring (1) which
can be removed with a screwdriver.
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
IMPORTANT Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.3.3 Repairing or replacing tyres
The tyres are "Tubeless" and must be replaced
or repaired if punctured by a specialized tyre
15