Commands And Control Instruments - Dolmar RM-72.13 H Manuel D'utilisation

4. COMMANDS AND CONTROL INSTRUMENTS

[4] 1
[4] 6
[4] 3
[4] 7
[4] 23
1. STEERING WHEEL
Turns the front wheels.
2. ACCELERATOR LEVER
Regulates the engine's r.p.m. The positions are indicated on a plate
showing the following symbols:
2
EN 10
[4] 11
[4] 21
[4] 5
[4] 4
[4] 2
[4] 12
[4] 22
Position «CHOKE» for starting up
Position «SLOW» for minimum
engine speed
Position «FAST» for maximum
engine speed
When moving from one area to another, put the lever in a position
between «SLOW» and «FAST» When cutting, go to the «FAST» po-
sition.
3. PARKING BRAKE LEVER
This lever is to stop the machine from
moving when it has been parked, and
must always be engaged before leaving
the machine.
– The brake is engaged by fully pressing
the pedal (11 - 21) and moving the lever
to position «A». When you take your
foot off the pedal it will be blocked by
the lever in the down position.
– To disengage the parking brake, press
the pedal again so that the lever returns to position «B».
4. KEY IGNITION SWITCH
This key operated control has four positions:
4
– If you release the key on «START», it will automatically returnto
«ON».
– After turning the engine on, turn the lights on (if fitted) by turning
«OFF» everything is switched off;
«HEADLIGHTS ON»;
«ON» activates all parts;
«START» connects the startermotor.
3