Connections; Cable Indications; Analog Connections; Digital Connections - Denon DCD-700AE Mode D'emploi

ENGLISH

Connections

NOTE:
• Do not plug in the power supply cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Making connections with the power turned on could result in noise or damage the speakers.
• Bunching the power supply cords and connection cables together could result in humming or noise.

Cable indications

Connect using the connection cables shown below.
Audio cable
A
Analog connections (Stereo)
(White)
L
(Red) R
Pin-plug cable
B
Digital connections (Optical)
Optical fiber cable

Analog connections

Signal direction
Audio signal
L
R
OUT IN
Stereo amplifier
A
AUDIO IN
L L
R R

Digital connections

There is a protective cap over the optical digital output terminal. Remove the protective cap and insert the
plug firmly until it locks.
¢ When connecting the optical digital output connector with an optical
transmission cable (commercially available)
Protective cap
Remove the protective cap, match the shapes then
insert firmly all the way in.

Connecting the power supply cord

L
R
NOTE:
• Insert the plugs securely. Incomplete connections will result in the generation of noise.
• Do not unplug the power supply cord while the set is operating.
6
ENGLISH
CD recorder, etc.
B
Match the
shapes
• Store the protective cap in a safe place so as not
to lose it, and use it when not using the terminal.
Connections
OPTICAL
IN
AC outlet
AC 230 V, 50 Hz