Installation Procedure - Kenwood LZ-601 Mode D'emploi

Installation
Accessorie
1

Installation Procedure

1
To prevent short circuits, remove the key from the ignition and disconnect the · terminal
of the battery.
2
Make the proper input and output cable connections for each unit.
3
Connect the wiring harness cables in the following order: ground, ignition.
4
Connect the wiring harness connector to the unit.
5
Install the unit in your car.
6
Reconnect the · terminal of the battery.
2WARNING
• This product is intended for use with 12V DC negative ground power only. Do not connect it
to any other power supply
• To prevent shorting, disconnect the battery wire from the negative terminal of the battery
during installation.
• Be sure to firmly stabilise this product. Do not install it in a location which is not stable.
• Follow the installation and wiring procedures described in this manual. Improper wiring or
modified installation can not only result in malfunction or damage to the unit but may also
result in an accident.
• Do not install the unit in the following locations.
•A location which interferes with the operation of the air bag system.
•A location subject to direct sunlight, subject to the air from the air conditioner, or subject to
moisture or high temperature.
\This may cause deformation of the monitor unit.
2CAUTION
• If your car's ignition does not come with an ACC position, connect the ignition wires to a
power source that can be turned on and off with the ignition key. If you connect the ignition
wire to a power source that receives a constant voltage supply, as with battery wires, the
battery may die.
• If the fuse blows, first make sure that the wires have not caused a short circuit, then replace
the old fuse with one with the same rating.
• Do not let unconnected wires or terminals touch metal on the car or anything else
conducting electricity. To prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car
are working properly.
• Insulate unconnected wires with vinyl tape or other similar material.
• Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
English - 3