Programming Additional Transmitters - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Programming additional transmitters

In addition to the master transmitter, up to 15 further trans-
mitters (of which a maximum of three can be sensors) can be
programmed in the radio receiver.
Press the programming button of the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now press the programming button of the new transmitter you wish to pro-
gram again for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been programmed.
24 - en