gigamedia AXA2EMK2KW Manuel Utilisateur page 12

GGM AXA2 - Series access control
11. Multi working mode:
There are 7 working mode with this device.
1. Wiegand Reader
2. Standalone for single door
3. Standalone for two doors
4. With external reader for two doors
5. Two units interlocked for two doors
6. Anti-passback for single door
7. Anti-passback for two door
The factory default is Standalone for single door (we can change the default model according to custo-
mer order). User can modify the working mode, when the device reset to factory default,the setting is
still valid.
11.1 Wiegand Reader mode
In this mode, the access control works as reader,connected with the common access controller, it has
following function.
Modify master pin
Set facility code
Set the card transmission format
Set the keypad transmission format
Set optional setting
Anti-Tamper alarm
When LED level is low,indicator light(LED) will turn into green, after 30 seconds or LED level rising,
LED will back to normal.
When BZ level is low,the buzzer will beep,after 30 seconds or BZ level rising, the buzzer will back to
normal.
When it used as the reader, both card number and keypad transmits in Wiegang format,the output
data are shown by the low level of DO&D1 wire:
D0:low level means 0,green wire
D1:Low level means 1,white wire
The Pulse width of low level is 100uS,bit period is 1.6mS
The digits of card number can be set to 26-37 bit, should be matched with the controller.(Factory
default is 26Bit)
Keypad transmission can be set in the following 3 modes(modes can be set by user)
Model 0: Virtual card number
The reader will transmit the PIN data when it receives the last key(#) press after PIN code
Format: Decimal card number with 10 digits, Facility code(1st~4th digit)+PIN Code(5th-10th digit)
Facility code is any digits between 0~15,PIN code is 4~6 digits
Example:facility code :15
PIN code:9999
Press 9999 #, then output format will be: 0015009999
PIN code: 999999
Press 999999#,then output format will be 0015999999
11
User Manual
EN