Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GGM AXA2 - Series access control
EN
8.10
Set door relay time
14
Press
Note: 0~99 is to set the door delay time 0-99 seconds, factory default is 5 seconds
8.11
Set Relay mode
Relay setting -pulse mode
15
Press
Every time a valid card/tag read or PIN input, the relay will operate,
for the pre-set relay pulse time. (Factory default setting)
Relay setting-Toggle mode
15
Press
Every time a valid card/tag read or PIN input, the relay changes state,
which will not turn back until read card/tag or input PIN again
8.12
Set opening door by multi cards
16
Press
Note: the door will be opened only after reading all the valid multi cards up to the card quantity setting.
It is only for card entry mode (Factory default setting :1)
8.13
Add a series consecutive cards users
17
Press
Note: the card number must be consecutive card quantity is between 1~20000;
card number is 10 digits or 8 digits
8.14
User setting for Zone 2
The method is the same with Zone 1, corresponding menu should be 21,22,23,24,25,26,27
8.15
System setting
8.15.1 To set facility code
33
Press
Note: code should be 0~15, factory default setting :0
8.15.2 Wiegang Reader
31
Press
8.15.3 Standalone for single door(Factory default setting)
31
Press
8.15.4 Standalone for two doors
Press
31
8.15.5 With external reader for two doors
31
Press
8.15.6 Two units interlocked for two doors
31
Press
8.15.7 Anti-passback for Single door
31
Press
8.15.8 Anti-passback for two doors
Press
31
8.16
To set wiegang format
32
Press
0~99
#
0
#
1
#
card quantity
#
ID number #
card number #
0~15
#
0
#
1
#
2
#
3
#
4
#
5
#
6
#
26 34 37
#
card quantity #
8
User Manual
Publicité
Table des Matières
