Tool Safety - General International BS5205 Manuel D'installation Et D'utilisation

before turning power on. Left attached, these parts can fly off a rotating
part and result in personal injury.
11. MAKE SURE THAT SWITCH IS IN "OFF" POSITION
before plugging in cord to reduce the risk of unintentional starts.
12. NEVER STAND ON TOOL
Serious injury could occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
13. KEEP HANDS WELL AWAY FROM CUTTING SURFACES
and all moving parts. Do not clear chips and sawdust away with hands.
Use a brush.
14. SECURE WORK.
Use clamps or a vise to hold the work. It's safer than using your hands
and it frees both hands to operate the tool.
15. DISCONNNECT THE PLUG FROM POWER
before making any adjustments. Changing attachments or accessories
can be dangerous if the tool could accidentally start.

TOOL SAFETY

1. MAKE SURE ALL CUTTING TOOLS
are moving at operation speed before feeding.
2. DO NOT FEED THE MATERIAL TOO QUICKLY.
The tool will perform better and be safer working at the rate for which it
was designed.
3. NEVER LEAVE THE MACHINE WITH THE POWER ON.
4. DO NOT FORCE THE MACHINE.
It will do the job better and be safer at a rate for which it was designed.
Don't force a small tool or attachment to do the work of a larger
industrial tool. Don't use a tool for a purpose for which it was not
intended.
5. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and safe performance. Follow instructions for
lubricating and changing accessories. Keep handles dry, clean and free
from oil and grease.
6. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING
ANY ADJUSTMENTS.
Changing attachments or accessories can be dangerous if the tool
could accidentally start.
7. AVOID UNINTENTIONAL STARTING.
Be sure the switch is in the OFF position before plugging in. Do not
carry the tool with the power connected and your finger on the trigger.
8. KEEP GUARDS IN PLACE
and in working order. If a guard must be removed for maintenance or
cleaning, make sure it is properly attached before using the tool again.
9. DO NOT USE THE TOOL
if it cannot be switched on or off. Have your tool repaired
before using it.
10. CHECK FOR DAMAGED PARTS.
Before using this tool, any part that is damaged should be carefully
checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mountings, and other conditions that
may affect its operation. Inspect screws and tighten any ones that
are loose. Any part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated
elsewhere in the instruction manual. Have defective switches replaced
by an authorized service center. Don't use the tool if switch does not
turn it on and off properly.
11. OBTAIN ADVICE
from your supervisor, instructor or another qualified person if you are
not thoroughly familiar with the operation of this machine. Knowledge is
safety.
12. USE ONLY RECOMMENDED ACCESSORIES.
Use of accessories NOT recommended by General International may
result in a risk of injury.
170227
5