Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
Band saw head assembly
B
C
D
E
Wheel frame
F
G
H
Motor shaft pulley
I
V-belt
J
Pulley cover
K
Work stop rod
L
M
Vertical cutting support
N
Accessory pack
ASSEMBLY PROCEDURE
WARNING! For your own safety, never connect the plug to the power
source outlet or insert the switch insert key until all the assembly steps
are complete and you have read and understood the entire owner's
manual.
STAND
Attach the lower tray, wheels and transport handle in this order:
1. Locate the two 2 leg assemblies (B, fig 2 & 3).
2. Locate the tool tray (C, fig 2).
3. On both leg assemblies, open the hinged flap 90 degrees. (fig 3)
4. Place the two 2 leg assemblies about 18" (45 cm) apart.
5. Place the tool tray with the edges pointing up, between the 2 leg
assembies.
6. At each end, align the holes of the tool tray with the holes in the edge of
the leg assembly.
NOTE: the legs should fit equally well either way around.
7. Locate 8 M6 washers, 4 M6 hexagon nuts and 4 M6 x 10 hexagon head
bolts.
8. Place a washer onto each M6 x 10 hexagon head bolt.
9. Fully insert 1 hex head bolt with washer first, through each of the 4
holes of the tool tray, then the holes of the leg assembly.
10. Slide a washer onto the threaded ends of each hex head bolt.
11. Place a hex nut onto each bolt.
12. Be sure the stand is symetrical and stable.
13. Fully tighten the 4 hexagon nuts and bolts.
BAND SAW CONNECTING PLATES
1. Locate the two connecting plates (GG, fig 5) and place one connecting
plate on top of each leg assembly with the tabs inside.
2. Align the 3 bottom holes (b, fig 5) of each connecting plate with the 3
holes at the tops of each leg assembly.
1
2
1
2
1
1
1
1
1
1
1
1
1
1
170227
11
Publicité
Chapitres
Table des Matières
