Before First Use; Boiling Water - Inventum HW73W Mode D'emploi

2 | before first use
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove
all the packaging material. keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. before plugging into a socket, check that
the voltage in your home corresponds with the voltage
printed on the bottom of the appliance. put the appliance
on a flat, stable and heat resistant surface.
Before use you must fill the waterkettle to the maximum
level and boil this amount. do this twice. throw away the
boiled water and rinse the kettle with cold water. the
appliance is now ready to use. the kettle is only suitable
for boiling water. never fill the kettle with milk, tea,
coffee or other drinks. the minimum amount of water
must be 0,2 liters. the maximum amount of water to be
used is 1,0 liters.
3 | boiLing WAter
before plugging into a socket, check that the voltage in
your home corresponds with the voltage printed on the
bottom of the appliance. Put the appliance on a cool, flat
and stable surface. connect the appliance to an earthed
socket. you can adjust the length of the cord by pulling it
out from, or pushing it into, the interior of the appliance.
1. Open the lid by pushing the button.
2. fill the kettle with an amount of water and close the
lid by pushing it down.
3. place the kettle on the base and make sure that the
plug is in the socket.
4. switch the kettle on by pressing the on/off switch
down to position 1.
The red pilot lamp will light up. The kettle will now
boil the water.
5. the kettle will automatically switch off when the water
is boiled.
The pilot lamp will switch off.
if you want to boil the water again, you must wait
approx. 30 seconds before you switch it on again, so
that the switch can cool down. the kettle can also be
switched off at any time with the switch. When you take
the waterkettle off the base while boiling, it will switch
off. When you place the waterkettle back on the base the
water will continue boiling. if that is not necessary, switch
the kettle of by pushing the switch to position 0.
Attention! never switch the kettle on without water.
if, for whatever reason, the kettle is switched on without
water, the dry-boilprotection will automatically switch
the kettle off. put the switch back to "0". in this case take
the kettle off the base and let it cool down for several
minutes. After that, refill the kettle and switch it on
again. make sure that the lid is closed properly, if not the
kettle will go on boiling and will not automatically switch
off.
Attention! it may occur that you see condensation on the
base. this is completely normal and has no consequences
for the use of the waterkettle.
14