Appliance Description; Before First Use; Boiling Water - Inventum HW615 Mode D'emploi

2

appliance description

1. Spout
2. Anti-scale filter
3. Lid
4. Button for opening lid
5. Handle
6. Waterlevel-indicator
7. On/ off switch with pilot lamp
8. Base
3

before first use

Before you use the appliance for the first time, please do
as follows: Carefully unpack the appliance and remove
all the packaging material. Keep the material (plastic
bags and cardboard) out of reach of children. Check the
appliance after unpacking for any damage, possible from
transportation. Place the appliance on a stable and heat
resistant surface.
The minimum amount of water must be 0.5 liters. The
maximum amount of water to be used is 1.5 liters.
Before use you must fill the waterkettle to the maximum level
and boil this amount. Do this twice. Throw away the boiled
water and rinse the kettle with cold water. The appliance is
now ready to use.
The kettle is only suitable for boiling water. Never fill the kettle
with milk, tea, coffee or others drinks.
10
• English
HW615-instructions.indd 10
1
2
4

boiling water

Before plugging into a socket, check that the voltage in your
home corresponds with the voltage printed on the bottom
of the appliance. Put the appliance on a cool, flat and stable
surface. Connect the appliance to an earthed socket. You
can adjust the length of the cord by pulling it out from, or
pushing it into, the interior of the appliance.
1. Open the lid by pushing the button.
2. Fill the kettle with an amount of water and close the lid by
pushing it down.
3. Place the kettle on the base and make sure that the plug is
in the socket.
4. Switch the kettle on by pressing the on/off switch down to
position 1.
The pilot lamp will light up. The kettle will now boil the water.
5. The kettle will automatically switch off when the water is
boiled. The pilot lamp will switch off.
Attention: never switch the kettle on without water.
If, for whatever reason, the kettle is switched on without
water, the dry-boilprotection will automatically switch the
kettle off. Put the switch back up. In this case take the kettle
from the base and let it cool down for several minutes. After
that, refill the kettle and switch it on again. Make sure that the
lid is closed properly, if not the kettle will go on boiling and will
not automatically switch off.
3
4
5
6
7
8
15-12-2014 12:19:53