Attaching The Fall Prevention Wire; Attaching The Wiring Covers - Sony PSS-650 Manuel D'installation

Attaching the Fall Prevention Wire

Install an anchor point and attach the supplied fall prevention wire to make sure the projector cannot fall.
Use commercially available M10 anchor bolt, washer, and nuts. These parts are to be supplied by the customer. Use a
washer with an outer diameter of 40 mm (1
Note
About projector fall prevention
• Always provide fall prevention measures as described in this manual.
• The length of the supplied fall prevention wire supports the maximum height when using the extension pipe. After
adjusting the height, adjust the length of the wire to suit the adjusted height.
• If the supplied wire is insufficient, use a wire made of rust-proof material (for example, stainless steel).
• Use a gage of wire that has sufficient tensile strength to support the weight of the projector and brackets.

Attaching the Wiring Covers

1
After connecting the wiring and passing cables through the pipe, secure the cables in the pipe using cable clamps
(a) to the two locations (top and bottom).
2
When finished, insert the wiring covers into the outer pipe/inner pipe.
9
/ in.) or larger.
16
Wiring
cover
(a)
Projector mounting bracket
Attaching to the Ceiling
25