Troubleshooting - Dometic ORIGO E100 Notice D'utilisation

_Origo_E100_E200_E300.book Seite 13 Montag, 19. Januar 2009 6:12 18
Dometic ORIGO
➤ To activate the heating area push and turn the control knob to the desired
heat setting.
You may turn the knob clockwise or counter-clockwise:
– : Off position
– : Maximum heat setting
✓ The status LED is lit.
✓ The LED "Surface Hot" is lit.
➤ To deactivate the heating area turn the control knob to the off position ( ).
✓ The status LED is off.
✓ The LED "Surface Hot" is still lit.
This LED is turned off when the surface temperature is cool and safe to
touch (this takes approx. 12 min after deactivating the heating area).
8

Troubleshooting

Before contacting the service when the stove is not working or not working
satisfactorily, check:
Electricity is properly connected.
The circuit breaker is on.
The control knob is turned on.
Pan and stovetop surface are clean and dry.
The cooking pan has the correct size and is positioned correctly over the
heating area.
The pan has a flat and even bottom surface.
The heat setting is correct.
Troubleshooting
13