Indel B KD 50 ECOSMART Mode D'emploi page 29

KD 50 ECOSMART
INSTALLATION
• Remove the caps (2 pcs each side)
• Fix the cabinet with screws (2 pcs each side)
• Insert the caps
WARM SUGGESTION
-
No need to remove the drawer when installation.
-
Confirm the position is right before screw in.
VENTILATION
The compressor cooling system lets out heat and needs good ventilation. Therefore places with bad
ventilation are not very suitable. The Minibar must be installed in a place with an opening which guarantees
the necessary exchange of air, and it is of the utmost importance not to cover up or obstruct the grids which
provide the device with proper ventilation. One must also avoid positioning it in a place which is directly
exposed to sunlight or to other heat sources.
80 mm
KD 50 ECOSMART_19-03-2015
WARNING
You must fit the Minibar into the cabinet, guaranteeing
a cross section at the air inlet and outlet of at least
200 cm .
2
ENGLISH
27