Profi Care PC-BMG 3018 Mode D'emploi page 155

b. Then the current memory bank (U1 or U2) is flashing. See
Fig. 6-2. Press the "MEM" button to change to the other bank.
See Fig. 6-3. Confirm your selection by pressing the "START"
button. The current bank will also be confirmed automatically
after 5 seconds with no operation.
Fig. 6-1
c. After selecting the memory bank, the monitor starts to seek
zero pressure. See Fig. 6- 4.
d. The monitor inflates the cuff until sufficient pressure has built
up for a measurement. Then the monitor slowly releases air
from the cuff and carries out the measurement. Finally the
blood pressure and pulse rate will be calculated and displayed
on the LCD screen separately. Irregular heartbeat symbol (if
any) will blink. See Fig. 6-5 & 6-6. The result will be automati-
cally stored in the current memory bank.
Fig. 6- 4
PC-BMG3018_IM
Fig. 6-2 Fig. 6-3
Fig. 6-5 Fig. 6-6
155
04.07.18