Connecting The Cuff To The Monitor; Applying The Cuff - Profi Care PC-BMG 3018 Mode D'emploi

c. You can turn off the monitor by pressing the "START" button
when the minutes are flashing, then the time and the date
are confirmed.
d. The monitor will turn off automatically after 1 minute of no
operation; with the time and date unchanged.
e. After replacing the batteries, you should set the time and the
date again.

3. Connecting the Cuff to the Monitor

The cuff is attached to the monitor
when it is packaged. Should the cuff
become unattached, align the two
plugs and four brackets of the cuff with
the plug sockets and bracket sockets
of the monitor and press the cuff to the
monitor until the plugs and brackets are securely attached.

4. Applying the Cuff

a. Place the cuff around a bare wrist 1 - 2 cm above
the wrist joint on the palm side of the wrist.
b. While seated, place the arm with the cuffed wrist
in front of your body on a desk or table with the
palm up. If the cuff is correctly placed, you can
read the LCD display.
c. The cuff must be neither too tight nor too loose.
Notes:
1. Please refer to the cuff circumference range in
"Specifications" to make sure that the appropri-
ate cuff is used.
PC-BMG3018_IM
153
04.07.18