Metabo HPT C 12RSH2 Instructions De Sécurité Et Mode D'emploi page 21

NOTE:
* Perform cutting by overlapping the ink line with the laser line.
* When the ink line and the laser line are overlapped, the strength and
weakness of light will change, resulting in a stable cutting operation
because you can easily discern the conformity of lines. This ensures the
minimum cutting errors.
* In outdoor or near-the-window operations, it may become diffi cult to
observe the laser line due to the sunlight. Under such circumstances,
move to a place that is not directly under the sunlight and engage in the
operation.
* Do not tug on the cord behind the motor head or hook your fi nger, wood
and the like around it; otherwise, the cord may come off and the laser
marker may not be lit up.
Laser marker
switch
Marking
(pre-marked)
Workpiece
Fig. 19
Vise assembly
Move
Laser line
Groove
Fig. 20
Laser line
Fig. 18
Saw blade
Cutting width
Adjuster
(2) Then, turn the adjuster and shift the laser line. (If you
Turn
Ink lining can be easily made on this tool to
the laser marker. A switch lights up the laser
marker. (Fig. 18)
Depending upon your cutting choice, the laser
line can be aligned with the left side of the
cutting width (saw blade) or the ink line on the
right side.
The laser line is adjusted to the width of the
saw blade at the time of factory shipment.
Adjust the positions of the saw blade and the
laser line taking the following steps to suit the
use of your choice.
(1) Light up the laser marker and make a groove
of about 3/16" (5 mm) deep on the workpiece
that is about 25/32" (20 mm) in height and
5-29/32"(150 mm) in width. Hold the grooved
workpiece by vise as it is and do not move it.
For grooving work, refer to "13.Groove cutting
procedures" on page 33.
turn the adjuster clockwise, the laser line will shift to
the right and if you turn it counterclockwise, the laser
line will shift to the left.) When you work with the ink
line aligned with the left side of the saw blade, align
the laser line with the left end of the groove. (Fig. 20)
When you align it with the right side of the saw blade,
align the laser line with the right side of the groove.
English
21