Metabo HPT C 12RSH2 Instructions De Sécurité Et Mode D'emploi page 19

When changing the height of the 8 mm set screw, loosen the 6 mm wing bolt shown in
Fig. 13, then slide the sub fence (B) outward and incline the motor head to the left.
When changing the bevel angle to the right 45°, pull the set pin (A) on the direction shown in
Fig. 14-c and incline the motor head to the right.
When adjusting the motor head to 0°, always return the set pin (A) to its initial position as
shown in Fig. 14-c.
Indicator
(For left bevel scale)
8 mm bolt (B)
(Stopper for right 45° bevel angle)
Fig. 14-a
7. Securing the workpiece
WARNING:
8. Installing the sub table
8 mm bolt
6 mm knob bolt
Steel square
Holder
Height adjustment
bolt 8 mm
Always clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Base surface
Sub table
Fig. 15
Indicator
(For right bevel scale)
8 mm set screw
Fig. 14-b
Using an item such as a steel square, match
the upper surfaces of the base surface and
sub table. Adjust the vertical level of the sub
table by turning the 8 mm height adjustment
bolt. After the adjustment, secure the holder
with the 8 mm bolt on the rear of the base, and
secure the 6 mm knob bolt of the sub table.
Always use the sub table during operation
and fi x properly with 8 mm bolt. (Fig. 15)
English
Set pin (A)
8 mm bolt (A)
(Stopper for left 45° bevel angle)
Fig. 14-c
Pull
19