Maintenance And Cleaning; Accessories - Bosch AKE 30 LI Notice Originale

Masquer les pouces Voir aussi pour AKE 30 LI:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
OBJ_BUCH-1275-004.book Page 35 Monday, April 4, 2016 1:04 PM
Problem
Possible Cause
Continuous lighting
Battery not (properly) inserted
of the battery charge
Battery contacts contaminated
indicator 24
No charging proce-
dure possible
Battery pack defective
The charge control
Mains plug of battery charger not plugged in
LEDs 24 and 25 re-
(properly)
spectively, do not
Socket outlet, mains cable or battery charger de-
light up after insert-
fective
ing the mains plug in-
to the socket

Maintenance and Cleaning

 Warning: Switch off and remove battery from power
tool before adjusting or cleaning.
Note: To ensure long and reliable service, carry out the follow-
ing maintenance regularly.
For safe and proper working, always keep the power tool and
its ventilation slots clean.
Regulary check the chain saw for obvious defects such as
loose, dislodged or damaged saw chain and chain bar, loose
fixings and worn or damaged components.
Check that covers and guards are undamaged and correctly
fitted. Carry out necessary maintenance or repairs before us-
ing.
Note: Before returning the chain saw, ensure all oil in the oil
reservoir has been emptied.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the chain saw.
Replacing/Changing the Saw Chain and Chain Bar
(see figures C1–C4)
Check the saw chain and chain bar according to section "Ten-
sioning the Saw Chain".
The circular groove of the chain bar will wear particularly on
the lower edge with time. When replacing the saw chain, turn
the chain bar by 180° to allow even wear, thus extending
chain bar life.
Check the drive sprocket 28. If it is worn out or damaged due
to strain, have it exchanged by an authorized Bosch after-
sales service.
Sharpening the Saw Chain
Have your chain sharpened professionally at your authorised
Bosch after-sales service or sharpen it yourself with a sharp-
ening kit suitable for the chain recommended for your chain-
saw. Observe the sharpening instructions provided with the
sharpening kit.
Bosch Power Tools
Corrective Action
Properly insert battery into battery charger
Clean the battery contacts (e.g. by inserting and
removing the battery several times) or replace the
battery
Replace the battery
Insert mains plug (fully) into the socket outlet
Check the mains voltage; have the battery charger
checked by an authorised after-sales service
agent for Bosch power tools
Checking the Automatic Oiler
Proper functioning of the automatic saw chain oiler can be
checked by running the chain saw and pointing the tip of the
chain bar towards a piece of cardboard or paper on the
ground. Do not touch the ground with the chain and ensure a
safety clearance of 20 cm. If an increasing oil pattern devel-
opes, the automatic oiler is operating fine. If there is no oil
pattern despite a full oil reservoir, see section "Troubleshoot-
ing" or contact your authorized Bosch after-sales service.
After Use/Storage
Clean the moulded plastic housing of the chain saw using a
soft brush and clean cloth. Do not use water, solvents or pol-
ishes. Remove all debris, especially from the motor cooling
vents.
After 1 – 3 hours of use, remove the cover 13, the chain bar
10 and the saw chain 11, and clean them using a brush.
Clean the area under the cover 13, the drive sprocket 28 and
the chain bar assembly from adherant debris using a brush.
Clean the oil outlet 31 with a clean cloth.
If the chain saw is to be stored for a longer period of time,
clean the saw chain 11 and the chain bar 10.
Store the chain saw in a secure, dry place, out of the reach of
children.
Do not place other objects on the power tool.
Please take care to place down the chain saw with the oil filler
cap 4 facing upward.
When storing in the sales packaging, the oil reservoir must be
completely emptied.
 Do not modify this product. Unauthorized modifications
may impair the safety of your product and may result in in-
creased noise and vibration.

Accessories

Saw chain
AKE 30 LI . . . . . . . . . . . . . . . . . . . . . . . . . . . . F 016 800 256
Additional accessories
Saw chain oil, 1 litre . . . . . . . . . . . . . . . . . . . . 2 607 000 181
English | 35
F 016 L81 531 | (4.4.16)

Publicité

Table des Matières
loading

Table des Matières