Zone Program Menu - CALEFFI 210 Série Manuel D'installation Et De Mise En Service

ZONE PROGR M MENU
(to program the system operating times)
MODIFY
The controller allows setting up to 4 comfort periods (system on) for each single zone with daily start and end time,
and set temperature. In the times not programmed, the set back temperature will be maintained. The controller will
regulate the temperature in each single zone so as to maintain the set temperature by acting on the boiler and
valves. During initial configuration, the controller automatically assigns standard parameters to each zone (see the
diagram below).
Starting from the main menu select:
–>
MENU
Select the zone to be modified, for example LIVING ROOM. The following page will appear:
Start time
End time
Pressing the confirmation button in correspondence to the day of the week selected, you can modify the following
parameters:
DD
ADD
MODIFY
MODIFY
DELETE
DELETE
COPY
COPY
ZONE PROGRAM
THU
LIVING ROOM
24/04/14
START END SETP
07:30 08:30 22.0°C
12:00 13:30 22.0°C
18:00 22:30 22.0°C
OTHER TIMES 16.0°C
ZONE PROGRAM
Allows adding a time period with start, end time and setpoint (regulation temperature)
A maximum of four time periods can be set. Follow the on-screen instructions.
Allows modifying the values relating to an existing time period with start, end time and
setpoint (regulation temperature). Follow the on-screen instructions.
Allows to delete a time period. Follow the on-screen instructions.
Allows copying and using the settings of any one day of the week for all the other days.
Follow the on-screen instructions. This function is very useful if you want to have the same
program for all the days of the week. Repeatedly press the confirmation button.
–> MODIFY
MODIFY
14:48
SELECT A DAY
MONDAY
18
Temperature set for the
comfort period
Temperature set for the
set back period
(outside the set times)