Wall Mounting The Controller - CALEFFI 210 Série Manuel D'installation Et De Mise En Service

Wall mounting the controller

1.
For wall-mounting you can use a recessed box type Bticino Living
503E.
Secure the power supply on the bottom of the box.
Cut off the electric supply before making any electric
connection.
2.
Connect the 24 V dc power supply to the mains respecting the
correct polarity.
The maximum cross-section of the electric supply cables is
2,5 mm and the maximum length of the 24 V dc cables is
2
10 metres. Respect the polarity and make the electrical
connections keeping the insulation in order to prevent electrocution
or damage to the device. The power supply can be positioned in
the most appropriate position following the instructions.
3.
Remove the front panel of the controller by pressing on the two lower
hooks being careful not to damage the plastic.
Avoid touching or any pressure or contact on
the display in order to prevent permanent
damage.
4.
Run the 24 V dc electric supply cables through the central hole in
the rear panel of the controller.
8