Setting The Timer; How To Set The Present Time - Sanyo KHS3082 Mode D'emploi

01_KHS3682_EN.fm Page 13 Friday, February 12, 2010 12:42 PM

SETTING THE TIMER

NOTE
In the descriptions below, the following settings are used for the
temperature and time indicator selector button on the bottom front
section of the remote control unit.
• Temperature: °F
• Time: AM, PM

1. How to set the present time

(Example) To set to 10:30 pm.
Operation
1.
Press the CLOCK button
once if the time indicator is
not flashing.
2.
Press the Advance, Return
( , ) button until PM 10:30
is displayed.
3.
Press the CLOCK button
again.
OI-149-13-EG
Indication
The time indication alone
flashes.
The time can be set in 1-minute
increments. Holding down the
button advances the time rapidly
in 10-minute increments.
This completes the setting of the
current time.
2. How to set the OFF time
(Example) To stop the air conditioner at 11:00 am.
Operation
1.
Press the OFF TIME setting The timer
button once. displayed, and the present OFF
time is shown.
2.
Press the Advance, Return The timer
( , ) button until AM 11:00 blinks.
is displayed. The time can be set in 10-minute
increments. Holding down the
button advances the time rapidly
in 10-minute increments.
3.
Wait a few seconds, and then The timer
the setting is complete. stops blinking and the present
time is displayed.
3. How to set the ON time
(Example) To start operation at 7:10 am.
Operation
1.
Press the ON TIME setting The timer
button once. displayed, and the present ON
time is shown.
2.
Press the Advance, Return The timer
( , ) button until AM 7:10 blinks.
is displayed. The time can be set in 10-minute
increments. Holding down the
button advances the time rapidly
in 10-minute increments.
3.
Wait a few seconds, and then The timer
the setting is complete. stops blinking and the present
time is displayed.
Indication
indication is
indication
indication
Indication
indication is
indication
indication
13