Setting The Timer - Sanyo KHS0971 Mode D'emploi

1. How to set the present
time
2. How to set the OFF time
18

Setting the Timer

In the descriptions below, the following settings are used for the temperature and
NOTE
time indicator selector button on the bottom front section of the remote control.
• Temperature: °F
• Time: AM, PM
(Example) To set to 10:30 pm.
Operation
1. Press the CLOCK button once if
the time indicator is not flashing.
2. Press the Advance, Return ( ,
) button until PM 10:30 is
displayed.
3. Press the CLOCK button again.
(Example) To stop the air conditioner at 11:00 am.
1. Press the OFF TIME setting
button once.
2. Press the Advance, Return ( ,
) button until AM 11:00 is
displayed.
3. Wait a few seconds, and then the
setting is complete.
Indication
The time indication alone flashes.
The time can be set in 1-minute
increments. Holding down the button
advances the time rapidly in 10-minute
increments.
This completes the setting of the
current time.
The timer indication is displayed,
and the present OFF time is shown.
The timer indication blinks.
The time can be set in 10-minute
increments. Holding down the button
advances the time rapidly in 10-minute
increments.
The timer indication stops
blinking and the present time is
displayed.
OI-802-18-EG