Basic Procedure - Kenwood DPX-7200DAB Mode D'emploi

Installation/Connection
Part list for installation
(A) Mounting sleeve ( ×1 )
(C) Wiring harness ( ×1 )

Basic procedure

1
Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2
Install the DAB antenna.
See "Installing the DAB antenna" on page 35.
3
Connect the wires properly.
See "Wiring connection" on page 34.
4
Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
5 Connect the terminal of the car battery.
Press B SRC to turn on the power.
6
7
Reset the unit. (Page 4)
32
ENGLISH
(B) Trim plate ( ×1 )
(D) Extraction key ( ×2 )
Installing the unit (in-dash mounting)
Do the required wiring.
(Page 34)
Dashboard of your car
Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit before
installing.
2
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (commercially available).
Use only the specified screws. Using wrong screws might damage the
unit.
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.