Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SPLIT
CONDENSER
Position the condenser in the required place,
1
make the boreholes and secure with the
supplied screws.
1
Take the 3/8 piping through to the condenser.
2
Cut the 1/2 and 3/8 piping and secure H90
couplings with valve and M90º at the most
suitable measurement. Connect the cabling
with electros and pressure switch.
PIPING AND CABLE CONNECTION
The pipes and cabling should pass through
!
the most appropriate place in order to avoid
any sharp edges or twisting.
Clamps and screws are supplied to
secure the cables and piping; make sure
these are protected with edgebands and
sleeves.
Be careful to discard the excess cabling
in an appropriate place.
SEE PIPING AND CABLE CONNECTION
DIAGRAMS.
1
19
EN
®
Publicité
Table des Matières
