Westfalia 321 457 300 107 Instructions De Montage page 19

Installation Instructions:
Electrical System for Towing Hitch
Installing the electrical kit
1. Disconnect the negative battery terminal.
2. Remove the following coverings:
•
In the luggage trunk
Covering of luggage trunk bottom
-
Covering of the rear end plate
-
Right-hand and left-hand side covering of the luggage trunk
-
•
From the rear end plate
Covering for the cable leadthrough on the left-hand side
-
3. Starting in the luggage trunk, lead the cable end through the vehicle's cable leadthrough to
the outside up to the socket holder plate (Fig. 1/7).
4. Fit the rubber grommet and insert it into the cable leadthrough (Fig. 1/6).
Socket installation
5. Fit the socket gasket and connect the cable harness to the socket housing in accordance with
the pin assignment plan (Fig. 1/7) and push the rubber grommet against the socket.
6. Screw the socket onto the holding plate (Fig. 1/7) using the supplied screws and nuts.
Connecting the tail lights
7. Unplug the plug of the left-hand tail light (Fig. 1/5) and connect it to its counterpart on the
cable harness. Make sure that the plug locks firmly into place. Plug the residual plug back into
the tail light.
8. Lay the cable end with the two 6-pin plugs along the rear end plate to the right-hand tail light
(Fig. 1/8).
9. Secure the cable on the rear end plate.
10. Unplug the plug of the right-hand tail light (Fig. 1/8) and connect it to its counterpart on the
cable harness. Make sure that the plug locks firmly into place. Plug the residual plug back into
the tail light.
VW Golf IV/Bora 321 457 391 102 - 001 - 01/08 19