JB Systems Light The Winner II Mode D'emploi page 6

ENGLISH
• DMX-CONFIGURATION OF WINNER (OR ROVER):
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during
servicing.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened
and may not be corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally
free from any deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be
replaced.
• The mains cables must be in impeccable condition and should be replaced immediately
when even a small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation
openings should be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• The cleaning of internal and external optical lenses and/or mirrors must be carried out
periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surroundings can cause
greater accumulation of dirt on the unit's optics.
• Clean with a soft cloth using normal glass cleaning products.
• Always dry the parts carefully.
JB SYSTEMS®
OPERATION MANUAL
7/48 WINNER2 / ROVER
ENGLISH
• Clean the external optics at least once every 30 days.
• Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified
personnel!
SPECIFICATIONS
Mains Input: AC 230V, 50Hz
Fuse: 250V 5A fast blow (20mm glass)
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
Lamp: ELC 250W / 24V
Size: 50 x 20 x 15.5cm
Weight: 10kg
Every information is subject to change without prior notice
JB SYSTEMS®
OPERATION MANUAL
8/48 WINNER2 / ROVER