Possible Causes - Siemens slider SL45 Notice D'utilisation

en
Tips to help you save energy
Steam production consumes the most energy. To help
minimise the energy used, follow the advice below:
• Start by ironing the fabrics that require the lowest
ironing temperature.
Check the recommended ironing temperature in the
label on the garment.
Trouble shooting
Problem
The display does not
react when touched.
" " icon flashes
icon flashes.
" " icon flashes.
When touching the
display, the beep cannot
be heard.
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to smoke
when switched on.
Water flows through the
holes on the soleplate.
18

Possible causes

• Dirt on the display.
• Fingers are too cold.
The steam release button (13)
on the iron handle has not been
pressed during the last 8 minutes,
and the auto shut-off system has
been activated.
Water tank is empty.
Boiler and filter must be rinsed.
The beep has been deactivated.
• There is a connection problem.
• The main power button is not
switched on.
• The main power button is not
switched on.
• The temperature is set to a low
position.
• During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
• The steam function is being used
before it has reached the correct
temperature.
• The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
• Regulate the steam according to the selected
ironing temperature, following the instructions in this
manual.
• Try to Iron the fabrics while they are still damp and
reduce the steam setting. Steam will be generated
from the fabrics rather than the iron. If you tumble dry
your fabrics before ironing them, set the tumble drier
on the 'iron dry' programme.
• If the fabrics are damp enough, turn off the steam
regulator completely.
Solution
• Clean the display with a damp cotton
cloth (not too wet).
• Warm your fingers a little bit and try
again.
Press the steam release button again to
switch the steam station back on.
Fill the water tank.
Rinse the filter and the boiler according
to the cleaning instructions in this manual
(see section F).
Activate it according to instructions in this
manual. (6. Beep activation/deactivation)
• Check the mains cable (5), the plug
and the socket.
• Set the main power button (9) to the "I"
position (illuminated in red).
• Set the main power button (9) to the "I"
position (illuminated in red).
• Set the temperature to the desired
position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing at
low temperatures.
• Point the iron away from the ironing
area and press the steam release
button until steam is produced.