Other Indicators - Siemens slider SL45 Notice D'utilisation

en
Low steam flow
Medium steam flow
High steam flow
To change the amount of steam manually, touch the
icon on the display (8) repeatedly. The steam generator
runs through the following cycle:
The selected icon flashes
corresponding to each steam level is reached. Steam
is now ready to be released by pressing the steam
release buttons (13 or 14*).

5. Other indicators:

Indicates (flashing) that the auto shut-off
system has been activated.
Indicates (flashing) that the water tank (1)
is empty and must be filled.
Indicates (flashing) that the boiler and the
filter (12) must be rinsed.
6. Beep activation/deactivation
You can activate or deactivate a beep which may be
heard when touching the icons on the display (8).
To do this, simply touch the
same time for 3 seconds. After this time, a long beep
will be emitted indicating that the beep has been
activated or deactivated.
Preparations before ironing
For details of the following actions, please see the
related chapters of this user manual.
1. Release the iron from its secureLock system (10)
by pulling the lever located at the heel of the iron
backwards.
2. Remove any label or protective covering from the
soleplate (16).
3. Place the appliance horizontally on a solid, stable
surface. You may remove the iron pad (2) from the
appliance and place the iron on it on another solid,
stable, horizontal surface.
14
4. Fill the removable water tank (1).
5. Unwind the mains cable (5) fully, and plug it into an
6. Set the main power button (9) to the on position
7. The temperature and steam level automatic selection
Remark:
until the pressure
The steam generator will take more time to generate
steam only on initial heating up, or after performing the
de-scaling operation (calc'nClean).
When water is already present in the steam generator
during regular use, heat up time to reach the operating
temperature will be faster.
8. This appliance has a built-in water level sensor which
Important:
• Normal tap water can be used.
• The water tank (1) can be refilled at any time while
• To avoid damage and/or contamination of the water
and icons at the
(A)
• The iron is not designed to rest on its heel. Please
• The iron pad can be placed into the specially
• During its first use the iron may produce certain
earthed socket.
(illuminated in red).
function will be selected by default.
This allows you to start ironing without having to
select the steam or temperature levels.
If required, you can select your preferred setting
manually by using the touch icons on the display
(8).
The selected temperature and steam icons will stop
flashing after a time, indicating that the appliance is
ready to use.
indicates when the water tank (1) must be filled.
The icon will flash when the water tank is empty.
To prolong the optimum steam function you can mix
tap water with distilled water 1:1. If the tap water in
your district is very hard, mix tap water with distilled
water 1:2.
You can inquire about the water hardness with your
local water supplier.
using the appliance.
tank and the boiler, do not put perfume, vinegar,
starch, descaling agents, additives or any other type
of chemical product into the water tank.
Any damage caused by the use of the
aforementioned products,
guarantee.
always position it horizontally on the iron pad (2).
designed recess on the appliance or somewhere
suitable alongside the ironing area.
Never rest the iron on the appliance without the
iron pad!
vapours and odours, along with white particles on
the soleplate, this is normal and will stop after a few
minutes.
will void the