Recommended Accessory; Cleaning & Maintenance; Advice On Disposal - Siemens slider SL45 Notice D'utilisation

7. Holding your steam generator in the lateral position
and using a jug, fill the boiler with 1/4 litre of water
and replace the filter.
8. Shake the base unit for a few moments, unscrew the
filter again and empty the boiler completely over a
sink or bucket.
For best results, we recommend that this operation
is performed twice.
Important: before re-closing, make sure no water
remains in the boiler.
f
9. Replace and tighten the filter.
To reset the "Clean" counter, switch the steam
station on and off twice, keeping it off for at least 30
seconds each time.
(on → 30s off → on → 30s off → on)
Rinsing the iron steam chamber (G)
Caution! Risk of burns!
This procedure helps to remove scale particles from the
steam chamber.
Perform approximately every 2 weeks, if the water in
your area is very hard.
a) Ensure that the iron has cooled down.
b) Set the temperature to the
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power button
f
(9) to the "I" position, (illuminated in red).
e) Set the steam setting to
stops flashing.
f) Hold the iron over the sink or a container to collect
r
the water.
g) Press the steam release button (13) and gently shake
the iron. Boiling water and steam will be released,
r
carrying scale and/ or deposits that might be inside.
This process may take from 5 up to 10 minutes.
Please note that if you have filled the water tank to
r
the maximum, you do not have to continue until it is
completely empty, but just long enough so that there
are no more scale deposits appearing from your iron
r
hand set.
h) Set the temperature to the
pressing the steam release buttons (13-14*).
The water in the steam chamber will start evaporating.
Wait until all the water inside the chamber has been
r
evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over a dry cotton
r
cloth.

Recommended accessory

The SL45 steam station produces a high amount of
steam for best performance.
Therefore, the best additional accessory would be the
Siemens active-ironing board TN10100 / TN10200.
Cleaning & Maintenance
Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
1. After ironing, disconnect the plug and allow the
2. Wipe the housing, handle and iron body with a damp
3. If the soleplate is soiled with dirt or scale, clean it
4. If the cloth is synthetic, it may melt due to the high
5. Never use abrasive products or solvents. To keep
Storing the appliance (H)
1. Always allow the appliance to cool down before
setting.
2. Set the main power button to the "0" position (the red
3. Place the iron on the iron pad (2), standing on the
and wait until the icon
4. Store the mains cable (5) and steam hose (6) in the
5. Use the iron´s handle when moving the appliance,

Advice on disposal

Our goods come in optimised packaging. This basically
consists of non-contaminating materials which should
setting, without
be handed over to the local waste disposal service as
secondary raw materials. Your local town council can
give you information about how to dispose of obsolete
appliances.
appliances as applicable throughout the EU.
Attention! Risk of burns!
appliance to cool down before cleaning.
cotton cloth.
with a damp cotton cloth.
temperature on the soleplate (16). Switch off the
steam and rub off any residue immediately with a
thickly folded, dry cotton cloth.
the soleplate (16) smooth, you should avoid hard
contact with metal objects. Never use a scouring
pad, or chemicals to clean the soleplate.
storing it.
light will go off) and disconnect the mains cable.
soleplate, and fix it by inserting the tip of the iron into
the front slot and moving the secureLock lever (10)
against the heel of the iron.
storage compartment (4). Do not wrap the cords too
tight.
as shown in figure H, or use the carrying handles (3)
on either side.
This appliance is labelled in accordance
with European Directive 2002/96/EG
concerning used electrical and electronic
appliances (waste
electronic equipment -WEEE).
The guideline determines the framework
for the return and
en
electrical and
recycling of used
17