Mitsubishi Electric PFD-P VM-E Série Manuel D'installation page 16

surface.
Follow the procedures below when separating the sections.
Necessary tools and materials:
1 piece
this order by removing the hinges and the screws on the unit as shown in
band.
and the bottom of the unit to be separated. Be sure to re-tighten bolt 2 after
A
C
E Front panel: 2 chains
G Rear panel: 8 screws
I Rear panel: 7 screws on each
K Bolt 1
M Screw
<Dimensions and weight of parts>
Heat exchanger
*1
Fan unit
Decoration
—
panel
A Linear expansion valve wiring
C Remote controller wiring
E Thermistor wiring Float switch wiring
16
Requires brazing
1
2 loose enough to allow the top
B Filter cover
D
F
H
J Front panel: 2 hinges on each
L Bolt 2
780
780
— —
B Clamp
D Lamp wiring
A
C Drain pan
D
E
F
A Control box
C Fan
E Bottom section of the unit
G Piping side
To put the top and bottom sections of the unit together, follow the procedures
above in the reverse order.
before putting the panels together.
rectly. Use a cable tie and bundle the wires as they were before.
board that is supplied.
A B CN31
D CN21 E
G Connector location on the board
I LEV2A J Connector location on the adapter board
if the units fall or topple over.
B
B Motor
D Supporting wood piece
F Heat exchanger
H Top section of the unit
2 as shown in
2 .
C CN20
F CN22
H LEV2B
-