Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Defaults and Alarms
The tables below give the default values of severity associated with the failures.
Alarms
SPI :
SDH Physical Interface
SPI-LOS
SPI-TF
RST : Regenerator Section Termination
RST-LOF
MST : Multiplex section Termination
MST-EBER-B2
MST-SD-B2
MST-AIS
MST-RDI
MSP : Multiplex Section Protection
PAM
SCM
OTM
MSA : Multiplex Section Adaptation
AU-AIS
AU-LOP
HPOM : Higher Order path Overhead Monitor
HO-RDI/G1
HO-TIM
HO-SD (VC4)
HO-UNEQ
HPT : Higher Order Path Termination
HO-SLM
HO-SD (VC4)
HO-TIM
HO-RDI/G1
HO-UNEQ
HPA : Higher Order Path Adaptation
TU-LOM
TU-AIS
TU-LOP (TU3)
TU-LOP (TU12)
No reproduction or communication without the written consent of SAGEM SA
Description
Loss Of Signal-
Transmit Fail
Loss Of Frame
Bit Error Rate > 10
Signal Degrade –B2
Alarm Indication Signal
Remote Defect Indication
Protection Architecture Mismatch
Selector Control Mismatch
Operation Type Mismatch
Administrative Unit – Alarm Indication Signal
Administrative Unit – Loss Of Pointer
High Order Path –Remote Defect Indication
High Order Path –Trace Identifier Mismatch
High Order Path –Signal Degrade
High order Path – Unequipped
High Order Path -Signal Label Mismatch
High Order Path –Signal Degrade
High Order Path –Trace Identifier Mismatch
High Order Path -Remote Defect Indication
High Order Path –UNEQuipped
Tributary Unit - Loss Of Multiframe
Tributary Unit – Alarm Indication Signal
Tributary Unit - Loss Of Pointer
Tributary Unit - Loss Of Pointer
Table 2-11 : Alarms and severity (1/2)
-3
on B2 Byte
Installation and User Guide - N56717020104
2 - OPERATION
Severity
Major
Major
Major
major
minor
Non-alarmed
Non-alarmed
minor
minor
minor
Non-alarmed
major
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
Non-alarmed
minor
Non-alarmed
major
minor
Page A2-15
Publicité
Chapitres
Table des Matières
