Installing Accessories - Ferm SSM1005 Notice Originale

• Do not remove any wood debris etc, in the
vicinity of the saw with your hands while it is
running. Turn the machine off before removing
the wood debris.
Immediately switch off the machine when
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Mains connection
Only use earthed sockets with earthing wire
connected per the regulations.
Replacing the mains connection cable
The mains connection cable may only be replaced
by a special cable in a specialised workshop.
Replacing cables or plugs
Dispose of old cables or plugs immediately after
replacing them. It is dangerous to connect the plug
of a loose cable to a wall socket.
Using extension cables
Only use an approved extension cable,
corresponding to the machine power use. The wires
must have a minimum cross section of 1.5 mm
If the cable is on a reel, it must be fully paid out.

3. INSTALLING ACCESSORIES

Always disconnect the machine from the
main power supply before carrying out
any maintenance work
Installing the protective cover
Fig.B
• Before commissioning the machine, the
protective cover (5) must be installed.
6
• Insert the screw from the inside left, then affix
the washer and the safety ring from the right
side. The safety ring (A) may be left out
optionally.
• Screw the knurled nut in tight.
Installing the cross guide
Fig.C
The cross guide (3) allows material to be bevelled,
and can be simultaneously used to support the
material as it is fed through the saw.
Mounting the rubber feet
Fig. G
The enclosed rubber feet contribute to a steady
position of the scroll saw on your worktable
• Place the rubber foot on its place
• Connect the rubber foot with help of the
enclosed bolt, ring and nut
• Tighten the nut with a wrench
Sawdust blower
Fig. H
The sawdust blower keeps the workpiece clean for
more accurate scroll cuts. For best results, always
direct air flow from the blower tube at blade and
workpiece. To adjust, simply bend to desired
position.
Installation
• Place the sawdust blower on the hole on top of
the machine
• Turn the blow pipe clockwise into the hole
4. OPERATION
Always observe the safety instructions
.
2
and obey the relevant regulations.
Start - Push the green ON-switch to start the
machine
Stop - Push the red OFF-switch to stop the
machine
Tilting the table
Fig.D
The scroll saw table can be tilted through 45°.
To do so:
• Lock the locking arm underneath the table.
• Manually tilt the table until the desired angle