Brita PROGUARD Coffee Mode D'emploi page 68

Step
Flushing of the PROGUARD Coffee system
#6
Close the bleed valve and remove the 25cm black tube
6.3
Depending on the local mains water supply pressure wait 20 – 40 minutes until the tank
is fully filled with filtrate. Once the tank is fully filled, the "click"-sound that was produced
by the non-electric pump up to this point in time is silenced.
6.4
EN
Releasing of the accumulated tank water (filtrate):
• Insert the black 25cm tube into the sampling valve
• Place a bucket (~10 litres) beneath the tube
• Open the sampling valve and wait until all storage water has been released from the tank
• Close the sampling valve and discard the collected tank water into the drain
6.5
1
68
≥2,6
2
20 – 40
min.