Brita PROGUARD Coffee Mode D'emploi page 55

Step
Preparation and positioning
#1
• Remove the metal cover at the front
• Place PROGUARD Coffee in front of its intended place of operation
1.4
Required accessories that are not included in the scope of delivery:
Hose (2x):
• To link the mains water supply (the thread size depends on the local conditions) to the
shutoff valve G 3/4" male thread
• To connect the PURITY C50 Fresh filter head's G 3/8" male thread with the coffee
1.5 machine's water inlet connection (the thread size depends on the coffee machine)
Backflow preventer (1x):
• Make sure to install a backflow preventer that matches the local regulations. For more
information refer to chapter 2: Operating and Safety Instructions
• Install the backflow preventer at any position between the mains water supply and the
pre-filter head's male thread (inlet)
Checking the local waste water connection:
• Make sure in advance that you can later hang the waste water tube deeply into the
water drain (syphon)
• Make sure you can later fix the waste water tube with the cable tie
1.6
EN
OK?
OK?
55