English
- Place the switch (5) on the ON position and wait for
the machine to reach the required pressure (about
5 minutes), place a container under the unit (10),
slowly lift the lever (1) completely and hold it in this
position so as to fully discharge the water contained
in the boiler. Subsequently switch the machine off
and remove the plug from the power socket, open the
steam tap knob (3) anticlockwise and wait until all
the steam has been discharged from the steam pipe
(11) provided, open the boiler cap (2) anticlockwise
and turn the machine upside-down to eliminate all the
remaining water from the boiler. Fill the boiler again
with fresh water and use it to rinse of the machine
inside to eliminate any residues of the solution.
6.1 – GENERAL SAFETY RULE
If the pressure inside the boiler exceeds the maximum
pressure, for any anomaly, the system will activate
the safety valve (2) which it will start whistling and,
by opening, will start to abundantly discharge steam
through the condensation basin.
Switch the machine off, avoid any manipulation and
refer to the authorised SERVICE CENTRE.
46