System Utilisation - Beeper RW043P Manuel D'installation

7. SYSTEM UTILISATION

PRECAUTIONS FOR USE
• The rear view camera can not under any circumstances replace the vigilance and responsibility of the driver.
• The reversing video is an information tool , vehicle security and people close to it is the responsibility of the driver only , the driver must look if obstacles or people are near his vehicle
. Our responsibility can not be engaged in case of collision.
• Only the driver's responsibility to assess the obstacles and must adopt a careful and prudent behavior while driving so as not to endanger persons or cause damage.
• If necessary , clean the screen should be done using a slightly damp soft cloth , do not press on the LCD screen is not damaged .
• If necessary , clean the camera lens must be done using a soft damp cloth.
ENABLING AND DISABLING SYSTEM
The system is activated automatically when reverse travel of the vehicle . It turns off automatically when passing another gear or neutral.
TEMPLATES VIEWING DISTANCE
Depending on the type of configuration created during the installation of the product lines template viewing distances appear pop on the screen. This template is indicative it to you to
judge distances visible obstacles on the screen. These lines of template can be disabled to install the product. If you want to change the activation or deactivation of lines template
subsequent to the initial installation , you need to get closer to your installer.
ACCESS MENU
To adjust the settings of your screen , simply press the center button on the back of the screen (as shown against)
LUMINOSTE
Increase = low button Decrease = up button
CONTRAST
Increase = low button Decrease = up button
SATURATION
Increase = low button Decrease = up button
TINT
Increase = low button Decrease = up button
MODE 16:9 default press low or up button to scroll
LANGUAGE
French default press the up or low button to scroll
RESET Press the up or low button to return to the factory setting
To move from one setting to another, press the central button
To exit, go around the menu or wait for 6 seconds.
17
Decrease (-)
Menu
Increase (+)