Interventions On The Machine; Replacing Wheels - GGP ITALY 102 Manuel D'utilisation

The machine comes with a connector (1) for recharging; this is
connected to the corresponding connector for the special
"CB01" or "FIGHTER" maintenance battery-charger supplied
(if included) or available on request (
IMPORTANT
This connector must only be used for
connection to the "CB01" or "FIGHTER"maintenance battery-
charger. For its use:
– follow the instructions in the relevant user manual,
– follow the instructions in the battery manual.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
EN 30
9.5).
If this is not sufficient to achieve an even cut, please contact
your Dealer for the adjustment of the alignment of the cutting
deck.
6.3.2 Adjustment of the spring of the pawl for hooking
the grass-catcher
If the grass-catcher tends to
jump about and to open up
when going over rough ground,
or if it has difficulty in hooking
back on after being emptied,
the tension of the spring will
need to be adjusted (1).
Change the hooking point by
using one of the holes (2) until
the required result is achieved.

6.3.3 Replacing wheels

Stop the machine on flat ground
and put a block under a load-
bearing part of the frame on the
side that the wheel is to be
changed.
The wheels are held by a snap
ring (1) which can be eased off
with a screwdriver.
1
2
1
2