Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

– Never touch the mains plug with wet
hands.
f Do not run over, crush or pull the
power supply cable or extension lead,
otherwise it may be damaged. Protect
the cable from heat, oil and sharp
edges.
– The extension lead must have a
cross section in accordance with the
operating instructions and be protected
against splashed water. The
connection must not be in water.
– Always wear gardening gloves when
handling
or working near the sharp tines/blade.

INTENDED USE

This product is intended for domestic, lawn rak-
ing, scarifying or verticutting of lawn.
ASSEMBLY
For Your Safety
_ Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
_ The tines/blades continue to rotate for a
few seconds after the machine is switched
off.
_ Caution – do not touch rotating
tines/blades.
_ Always wear gardening gloves when han-
dling or working near the sharp tines/blade.
1. Open the packing and take out all
parts
2. Assemble the upper handles with
two nuts and two long screws (fig.
M1)
3. Assemble the lower tube (fig.M2)
-
Stick the tube in the holes and make
sure inserting fully home. Lock the
screws(1).
-
4. Attaching switch box,( fig. M3)
Position switch box (4) on the upper handle
and make sure to aim at the two holes(2).
Cover the switch bracket then fasten switch
box with two screw (K). Fasten switch cable (3)
with the clips (L) on the handle rod.
26

Publicité

Table des Matières
loading

Table des Matières