Operating Instructions - Skil LL9322G-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial
chemicals, and bleach or bleach containing products, etc., can cause a short circuit.
Applications
Your Self-Leveling 360 Degree Cross Line Laser can be hand-held for point marking and
simple alignment by sight, or it can be used to make a "chalk line" when in the lock mode. It
also can be mounted on a standard 1/4" tripod (included) to project laser lines on walls. It is
ideal for the following applications:
Hanging pictures, photos, or artwork on walls
•
Wallpapering and stencil work
•
Framing doors and windows
•
Installing electrical wiring and pipes
•
Mounting wall fixtures, electrical outlets, switches and lighting
•
Installing a drop ceiling
•
Painting
•
Installing closets
•
Laying tile and flooring
•
Charge the Tool and Monitor
Charge
NOTE: The tool is shipped partially charged;
charge the battery before first use.
R e c h a r g e t h e t o o l f o r a p p r o x i m a t e l y 5
hours after the battery depleted. It is not
recommended to recharge the tool for more
than 24 hours after each use.
a. Insert the USB interface of the USB charging
cable into the USB port of the power supply
(not included).
b. Insert the charging plug into charging port
of the tool, making sure that the two are
properly connected.
c. Connect the power supply (together with
USB charging cable) to the power outlet.(FIG. 2)
NOTE: Do not operate the tool during charging.
The LED indicator for battery capacity will continuously flicker in different colors during the
charging process.
The LED indicator for battery capacity flickers red during charging when the charged battery
•
capacity will allow the tool to be operated for approximately 30 minutes or less.
The LED indicator light flickers yellow during charging to indicate that the charged battery
•
capacity will allow the tool to be operated more than 30 minutes but has not reached 90% of
full capacity.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool or charger in fluid or allow a
Fig. 2
Charging Plug
Power Supply (Not
included)
9