General Laser Tool Safety Warnings; Fcc Statement - Skil LL9322G-00 Guide D'utilisation

GENERAL LASER TOOL SAFETY WARNINGS

READ ALL INSTRUCTIONS BEFORE USING THE TOOL!
WARNING
the laser beam on only when using this tool.
Do not remove or deface any product labels.
Avoid direct eye exposure. The laser beam can
cause flash blindness.
Do not operate the tool around children or allow
children to operate the tool.
Do not place the tool in a position that may cause
anyone to stare at the laser beam, whether
intentionally or unintentionally.
Do not use on surfaces such as sheet steel that
have shiny, reflective surfaces. The shiny surface
could reflect the beam back at the operator.
Always turn the laser tool off when not in use.
Leaving the tool on increases the risk of someone
inadvertently staring into the laser beam.
Do not attempt to modify the performance of
this laser device in any way. This may result in a
dangerous exposure to laser radiation.
Do not attempt to repair or disassemble the tool. If unqualified persons attempt to repair
this product, serious injury may occur. Any repair required on this laser product should be
performed only by qualified service personnel.
Use of other accessories that have been designed for use with other laser tools could result in
serious injury.
Do not operate the tool outdoors.
Do not place or store tool under extreme temperature conditions.

FCC STATEMENT

The manufacturer is not responsible for radio interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
LASER RADIATION. Do not stare into beam. Class II laser product. Turn
AVOID EXPOSURE/EVITE LA EXPOSICIÓN/ÉVITEZ L'EXPOSITION
LASER RADIATION IS EMITTED FROM THIS APERTURE
LA RADIACIÓN LÁSER SE EMITE DE ESTA ABERTURA
CET OUTIL PRODUIT UN RAYONNEMENT LASER
CAUTION/PRECAUCIÓN/ATTENTION
LASER RADIATION-DO NOT STARE INTO BEAM
RADIACIÓN LÁSER: NO MIRE DIRECTAMENTE EL RAYO
RAYONNEMENT LASER – NE FIXEZ PAS DES YEUX LE RAYON LASER
PRODUCTO LÁSER CON SALIDA < 1mW. CLASE II, 520nm, 3,7V
polímero de litio
CUMPLE CON LAS SECCIONES 21 CFR 1040.10 Y 1040.11
Model / Modelo / Modèle: LL9322G-00
7.40 Wh
CAN ICES-3(B)/NMB-3(B)
MADE IN CHINA /
HECHO EN CHINA /
FABRIQUÉ EN CHINE
SERIAL NO. / SERIE NO. /
NUMÉRO DE SÉRIE
, 2000mAh
3