To Test The Bark Control Collar; Accessories - Petsafe Deluxe Bark Control Collar Guide D'emploi

To Test the Bark Control Collar

Important: To avoid feeling the Static Correction yourself, never touch
the two Contact Points simultaneously.
1. Turn the Mode Switch to TEST.
2. Hold the unit by the collar with the Indicator Light
facing towards you. The unit should be within 6-10
inches of your mouth.
3. In order to trigger the unit, say "Test" loudly into the
Sound Activated Sensor.
4. The Indicator Light will fl ash three times to show that it
is functioning properly.
5. If the Indicator Light does not fl ash, ensure that the
battery is properly installed, and/or replace the battery. If the Indicator Light
still does not fl ash, contact the Customer Care Center at 1-800-732-2677.
6. Return the Mode Switch to Low before replacing the Bark Control Collar
on your dog.
Note: The TEST Mode is not intended for normal operation. If the Bark Control
Collar is left in TEST Mode while on your dog, it can cause false correction and may
reduce battery life.
____________________________________________________________________

Accessories

To purchase additional accessories for your PetSafe
TM
Collar , contact the Customer Care Center at 1-800-732-2677 or visit our
website at www.petsafe.net to locate a retailer near you.
Component
Battery - two pack
Replacement Collar
Accessory Pack (Extra Contact
Points, washers, and battery)
Deluxe Bark Control Video (VHS)
10
®
Deluxe Bark Control
Part Number
RFA-67D-11
RFA-68
RFA-118
RFA-148
1-800-732-2677
TEST!
OFF
TEST
LOW
BAT