dirna Bergstrom bycool blue line FLAT 12/24 V Instructions De Montage page 24

FLAT
EN ES
Position the interior air distribution panel
9
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the ducts come up against the
unit's upper foam.
Important: The channellers must meet the
rubber to avoid air leaks.
9
EPDM
Seal
Cab roof
Upholstered
Tighten the nut in point 6a until it comes
10
up against the top part of the interior air
distribution panel.
10
EPDM
Seal
Cab roof
Upholstered
Place the console and centre the equipment on
11
the most suitable place on the cab roof. Once
centred remove the console.
Bycool Base
M6 Nut
M6 Stud bolt
Bycool Base
M6 Nut (8a)
M6 Nut
M6 Stud bolt
(A)
Channellers
Channellers
24
Foam
Internal air distribution
panel
Foam
Internal air distribution
panel
®