Build Worker BFOS1800-250P Mode D'emploi page 42

Remove the safety protective over (25) from the
saw table: Rotate screw to release cover, and
lift away from the machine.
Mount saw blade guard(12) at the riving knife
(11) and tighten with the wing nut. (Fig.16)
Attach duet extraction port (2) of the saw blade
protection with a suitable suction apparatus.
Switch ON/OFF:
Lift up the security cover of the safety-
ON/OFF switch(9). (Fig.17) and press the
green button 1=ON. (Fig.18).
To turn off press the red button 0=OFF.
Cutting height adjustment:
Use the adjustment tool to rotate the cut
height adjustment stub (10) Clockwise =
deeper cut, Anti clockwise = shallow cut
(Fig.19)
Vertical angle cuts
Fig.16
Use the adjustment tool to loosen the tilt
adjustment stub 914). The entire saw
mechanism is the free to tilt between 90°-
45°(Fig.21)
When the saw blades is at the correct angle,
secure it by re-tightening the tilt adjustment
stib (14)
Fig.17
Bevel cuts:
Set fence clamp (15) to the desired angle.
Attach bevel fence (15A) to fence clamp
using nuts and bolts provided (Fig.22)
Fig.18
Hold material to be cut against bevel fence
and silde fence clamp (15) along grooves in
saw table to guide cut. Fig.23
Fig.19
Fig.21
Fig.22
Fig.23