Build Worker BFOS1800-250P Mode D'emploi page 41

Mitre cuts:
Note: A mitre cut cuts the work place at an
angle between -45°and +45°against the
rear edge.
Starting position:
Ensure the saw head (16)is fully raised.
Ensure the saw blade (7) is vertical to the
saw table.(1)
Setting:
Loosen both mitre fence clamps (22) of the
fence(21), shift extendable fences outwards.
Set the desired angle.(Fig.10)
Tighten both nitre fence clamps (22).
Cut work piece as detailed under "Standard
cross cuts".
Bevel cuts:
Note: A bevel cut cuts the work piece at an
angle between 0°and 45°from vertical.
Starting position:
Ensure the saw head(16) is fully raised.
Position rotating fence(21) to 0°-position,
shift extendable fences outwards and tighten
mitre fence clamps(22).
Setting:
Use the adjustment tool to loosen the tilt
adjustment stub(14).
Tilt the saw head to desired angle(Fig11).
Tighten the tilt adjustment stub.
Cut work piece as detailed under "Standard
cross cuts".
Compound mitre cuts:
Note: The compound mitre cut is a
combination of mitre and bevel cuts. This
means the work piece is cut at an angle
other than 90°against the rear guide edge
and against the surface.
Starting position:
Ensure the saw head(16) is fully raised.
Set rotating fence(21) to desired angle, shift
extendable fences outwards and tighten mitre
fence clamps(22)
Use the adjustment tool to loosen the tilt
adjustment stub(14).
Tilt the saw head to desired angle and tighten
the tilt adjustment stub(14). (Fig.12)
Cutting:
Cut work piece as detailed under"Standard
cross cuts".
Fig.10
Setting up for table saw mode
WARNING!
Prior to machine setup: Turn machine off,
wait for the saw blade to stop, and unplug
Rotate fence (21) into the front 45°-position,
shift extendable fences outwards and tighten
the two mitre fence clamps(22). (Fig.13)
Ensure the saw head bevel tilt is 0°to the saw
table. (1)
Press release button(19) in, and pull saw head
down Fig 14.
Fig.11
Turn the locking lever (17) a quarter turn to the
left so that the bolt is engaged. (Fig 15)
Release the flip over catch(6) on the right side
to the front and carefully rotate the saw table(1).
(Fig.7)
Fig.12
Fig.13
Fig.14
Fig.15